The perfect kit for defect correction and finishing on very durable paint or paint that is in serious condition.
It consists of everything needed to tackle a complete polishing job in just 2 passes:
Diamond Cut 3000, an extreme premium compound specifically for corrections on particularly damaged traditional paints rather than on very tough ceramic clearcoats. It quickly and easily removes sanding marks, dullness, oxidation, overspray, orange peel and runs.
Final Cut 9000, a high-performance abrasive that is perfect for removing minor scratches, swirls, holograms and other polishing marks. It leaves an exceptional high-gloss finish with both rotary and orbital polishers.
The pads in this kit are for orbital or rotary polisher with 125mm or 150mm backing pad.
Kit includes:
Diamond Cut 3000 is the first step in correction as it is a very effective compound but at the same time leaves the surface with an excellent finish.
1. Combine Diamond Cut 3000 with the Green Pad.
2. Apply 4 pea-sized drops of product to the pad.
3. Spread the product over a 40x40 section with minimal speed.
4. Increase the speed (4-5), placing minimum pressure for the first 2 cross passes and increasing it with each pass.
5. Work until defects are completely removed and remove excess paste with the green Ultrasoft microfiber.
Final Cut 9000 is the ideal step to conclude the polishing phase, thanks to its microabrasives it easily removes holograms or small imperfections giving the surface an excellent gloss and depth.
1. Combine Final Cut 9000 with the White Pad.
2. Apply 4 pea-sized drops of product to the pad.
3. Spread the product, one section at a time, keeping the speed low by applying little pressure.
4. Work the surface until defects are completely removed.
5. Remove excess product with white Ultrasoft microfiber.
N. B. It is recommended to blow the pad often with compressed air and keep it as clean as possible.
| Customised product to order | No |
|---|
